AZEK C044-001 Guía de instalación Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 8
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
Page 2
Installing AZEK Resurfacing Bullnose Pavers
LEAVE 6.5"-7" OF
GRID REMAINING
4X8 PAVERS IN
DESIRED PATTERN
SUB-STRUCTURE
BULLNOSE PAVER
GRID
APPLY ADHESIVE
SCREW TABS
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
LEAVE 6.5"-7" OF
GRID REMAINING
LEAVE 6.5"-7" OF
GRID REMAINING
45°
SUB-STRUCTURE
BULLNOSE PAVER
4X8 PAVERS IN
DESIRED PATTERN
SCREW TAB
APPLY ADHESIVE
GRID
CUT BULLNOSE
PAVER 1 AS SHOWN
CUT BULLNOSE
PAVER 2 AS SHOWN
CUT BULLNOSE PAVER 4 AS SHOWNCUT BULLNOSE PAVER 3 AS SHOWN
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
Resurfacing Bullnose Pavers
LEAVE 6.5"-7" OF
GRID REMAINING
4X8 PAVERS IN
DESIRED PATTERN
SUB-STRUCTURE
BULLNOSE PAVER
GRID
APPLY ADHESIVE
SCREW TABS
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
LEAVE 6.5"-7" OF
GRID REMAINING
LEAVE 6.5"-7" OF
GRID REMAINING
45°
SUB-STRUCTURE
BULLNOSE PAVER
4X8 PAVERS IN
DESIRED PATTERN
SCREW TAB
APPLY ADHESIVE
GRID
CUT BULLNOSE
PAVER 1 AS SHOWN
CUT BULLNOSE
PAVER 2 AS SHOWN
CUT BULLNOSE PAVER 4 AS SHOWNCUT BULLNOSE PAVER 3 AS SHOWN
BULLNOSE PAVER TO BE FULLY
SUPPORTED BY SUB-STRUCTURE
BULLNOSE PAVER
SUB-STRUCTURE
GRID
Resurfacing Bullnose Pavers
Cut Grid to allow for adequate interaction
of Grid and Paver and so the bottom of the
Bullnose Paver is fully supported.
Choose a starting point based on the dimensions of the project and the desired pattern.
Fasten Grids on stair treads using 1.5" screws.
• Do not fasten grids on deck or at roof surfaces.
Apply 1/4" bead of adhesive to the top ribs of the Grid.
(Titebond PROvantage Landscape Adhesive is recommended).
Place Bullnose Paver onto the Grid, pressing rmly.
Screw down the visible tabs into the Grid.
Do not screw into deck boards except on stairs.
Screws are not recommended on at roof applications.
Slide adjacent Bullnose Pavers into place until nished.
(May need to cut off exterior tabs)
Let cure for a minimum of 72 hours.
Corner Assembly
Vista de pagina 1
1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios